Operational headquarters

Via Pietro Nenni 79/E
10036 Settimo Torinese (TO) – ITALY
T +39 011 0378820
T +39 011 0378821

Latest news

AMC Instruments Advises

The best articles, pictures and videos for our latest news, insights and events

Media & Article

How is an mrt equipment made?

(Reading time: 3 min)

Magneto inductive equipment is made for inspecting the inner and the outer part of ferro-magnetic ropes. The measuring head and the acquisition system constitutes the MRT equipment.  
In this article, you will learn the basic structure of this inspecting tool.


The measuring head or detector is made of magnets and sensors. Magnets induce a magnetic flux inside the rope to fully saturate it. Neodymium-Iron-Boron alloy (NdFeB) is a magnets combination providing a magnetic field more intense than others. This characteristic allows the magnetic flux to penetrate deeper inside the rope. If there are no defects inside the ropes, the magnetic flux flows without interruption. (Picture 1.)

how is an mrt equipment made 1

(Picture 1. Absence of defects)

When broken wires or defects occur, a modification of the magnetic flux lines appears (Picture 2.). This change, in value and direction, is detected by sensors that transform the physical phenomena in a readable signal. The closer the sensors are to the rope, the better is the result in terms of sensitivity.

how is an mrt equipment made 2

Depending on the inspection environment the shape of the device varies. The standard configuration for mobile application is a close architecture (Picture 3.), whilst in the cableway sector it is preferable an open architecture for hauling ropes (Picture 4.) because the device must pass on cableway slings  (video).

how is an mrt equipment made 3

(Picture 3. Mobile Device – Close Architecture)

how is an mrt equipment made 4

(Picture 4. Mobile Device – Open Architecture)

Both configurations allow the technician to inspect specific diameter range. To detect lower diameter range it is preferable to use a reduction bushing kit (we have already seen in the previous page that the closer the sensors are to the rope the better is the signal)


This part of the equipment is made of a data processor and a software for the interpretation. The acquisition system transforms the sensor’s inputs in a signal on a graph allowing the user to acquire, save and perform interpretation. Sampling rate per channel and resolution bit are key characteristics for designing the data processor, the higher is the sampling rate per channel the better will be the digital signal construction. The software (Picture 5.) is the human interface of the system and it must be provided with a deep training in order to avoid misinterpretation and wrong filtering. Real time acquisition is a mandatory feature to fulfill ISO4309 during the inspection.

how is an mrt equipment made 5

(Picture 5. Software for the interpretation)

The acquisition system is usually made of a data processor and portable computer, where the software is installed. Depending on the inspection environment we suggest two different configurations:

  • IAS-H : a rugged case with a pc highly suggested for complex inspection environment such as Offshore, Harbour, construction sites
  • IAS-T: a rugged tablet integrated with a data processor, highly suggested for inspection with limited space such as crane basket

Do not miss our news, services and training. Stay tuned!

Operational Headquarters

Via Pietro Nenni 79/E
10036 Settimo Torinese (TO) – ITALY
T +39 011 0378820
T +39 011 0378821
This email address is being protected from spambots. You need JavaScript enabled to view it.

© 2021 - AMC INSTRUMENTS - All rights riserved - P. IVA 09612820010

Cookie Policy - Privacy Policy - Credits